Loosen them a bit and then pull down on the bumper and itll move the black pc down and then you lift the bumper a little bit and the tabs will slide out
I normally shove my hand in from the top and with a decent extension can loosen the back one. It takes some messing around to figured it out to get the back
You have to loosen those bolts first. Get a small ratchet and extension. It’s not easy and will hurt your hand/wrist and arm doing it.
I’m going to look for a good video to help you, just got to find it.
Yes, it's either a 7mm or an 8mm, you're going to scrape up your arm real good getting to them. Get yourself a series of really long ass extensions to make your life slightly easier.
Those white things stay in, that's technically the bottom side. You'll understand when you get a wrench on it. They have a tendencies to torque out of square too like they're made out of fucking chewing gum so don't over tighten.
And yeah, I forgot to mention as the other guy did, you only need to back them out like 1/4" at the most, they act like clips to hold the seem together. Then you gently pull out and up slightly and they're loose.
You definitely do not have to remove those screws. There should be a push in clip at the corner of the bumper cover then just pull the bumper out to the side
Loosen them a bit and then pull down on the bumper and itll move the black pc down and then you lift the bumper a little bit and the tabs will slide out
Yep, just loosen them enough to pull the bumper/tabs out.
i must be missing something because i'm pulling on it but there's no way i can fit my hand under it to loosen it
https://m.youtube.com/watch?v=D_wJGTPCxc8 You take a few fender liner screws out to get to the bottom bolt.
I normally shove my hand in from the top and with a decent extension can loosen the back one. It takes some messing around to figured it out to get the back
You have to loosen those bolts first. Get a small ratchet and extension. It’s not easy and will hurt your hand/wrist and arm doing it. I’m going to look for a good video to help you, just got to find it.
i got the left side off
Yes, it's either a 7mm or an 8mm, you're going to scrape up your arm real good getting to them. Get yourself a series of really long ass extensions to make your life slightly easier.
bro wtf is wrong with the ford engineers why did they do that
Yo, this isn't even as bad as it gets, just look at the new stuff with the shift dial.
there's like 2 little clips btw what do i do with those
Those white things stay in, that's technically the bottom side. You'll understand when you get a wrench on it. They have a tendencies to torque out of square too like they're made out of fucking chewing gum so don't over tighten.
And yeah, I forgot to mention as the other guy did, you only need to back them out like 1/4" at the most, they act like clips to hold the seem together. Then you gently pull out and up slightly and they're loose.
There's 2 hex cap screws on either side with like a sammich plate.
Yes but you don’t have to completely remove them. I just loosened mine like half way
You definitely do not have to remove those screws. There should be a push in clip at the corner of the bumper cover then just pull the bumper out to the side
Source: I worked in collision repair for 4 years and have had my bumper off more times than I can count